View Transcript

EcoBead ™ Inspect Pattern Generation and Verification

Reach continuous improvement goals through adhesive savings and reduced waste. Economical and easy to use, the EcoBead Inspect lets you dispense short, intermittent bead patterns and verify the placement of adhesive on a surface.

Contact Us Adhesive Systems HOME

Find your local representative

Effective Continuous Improvement

The ability to inspect adhesive application is invaluable; but there has been no simple solution to meet this need – until now. No other solution is as easy or affordable as Nordson's EcoBead Inspect.

With a patented, simple, drop-in design, the EcoBead Inspect delivers significant adhesive savings through the stitching functionality while ensuring the integrity of the designated adhesive pattern through thermal detection.

Save Adhesive and Maintain Bond Strength

Easy Machine Learning & Verification

The EcoBead Inspect connects inline with an existing MiniBlue® II applicator cable. This inline connection allows the EcoBead Inspect to detect the applicator signal from the PLC so that it can learn the signal, break the signal into smaller beads for glue savings, and anticipate what the glue on the product should be. The need to reprogram your PLC or to add conventional pattern controllers and sensors to your line is eliminated.

Intelligent and Connected

Using a sensor mounted to the front of the applicator, the EcoBead Inspect verifies glue placement starting from the first product with no complicated programming. It can interface with a parent machine, and the output signal can be used to stop the line, illuminate a light tower, sound a horn or eject a product if your parameters for adhesive application are not met.