Can Ends

Nordson equipment applies and dries can end-lining compounds. Advanced Induction dryers use proprietary induction-heating technology, resulting in significant energy savings and reduced floor-space requirements.

Nordson induction dryers are significantly economical to operate compared to hot air ovens, resulting in noticeable energy savings and adding to the sustainability of can end manufacturing operations.   Just a fraction of the floor-space required for convection dryers is needed, even at production speeds exceeding 2,000 ends per minute.

Using Nordson induction-drying technology, iDry and EcoDry systems heat only the can end, not the air around them. Convection hot air heating systems heat the air surrounding the compound, so the outside surfaces dry first causing blistering as the trapped water inside the compound escapes. Induction heating allows compounds to dry from the metal out making the drying process faster and more complete, without creating blisters.  The iDry and EcoDry compound dryers run on a lower wattage than convection dryers while 85 to 90 percent of the power consumed is used directly to heat the ends, making it the economical choice in all production environments.  Both single- and dual-lane configurations are available. Dryers are available in different sizes to meet line speed requirements, keeping dryer length to a minimum and saving floor space.

 The EcoLiner Compound Gun is an accurate electronically-controlled dispenser for water-based compound.  It provides consistency and repeatability with durable construction.


Related Products

EcoLiner™ Compound GunEcoLiner™ Compound Gun

High-performance, electro-pneumatic gun provides precise cutoff and adjustable flow control for accurate material deposition in end lining and closure operations.

Can End SterilizersCan End Sterilizers

Nordson® can end sterilizers utilize innovative moderate frequency induction heating to sterilize simply, safely and efficiently with minimal operator intervention.

EcoDry® Compound DryerEcoDry® Compound Dryer

The Nordson® EcoDry® Compound Dryer is economical, compact, and specifically designed for smaller production lines with a wide range of can ends.

iDry® Induction Compound DryeriDry® Induction Compound Dryer

Nordson dryers are designed specifically for water-based end compounds using Nordson patented induction-heating technology.

MicroCoat® Lubrication System MC4000 SeriesMicroCoat® Lubrication System MC4000 Series

MicroCoat® Lubrication System MC4000 Series

Temperature Control UnitTemperature Control Unit

The Nordson® Temperature Control Unit provides an effective method to monitor and maintain material temperature by heating or cooling during can coating operations.

NH-4 HeaterNH-4 Heater

Nordson® heated airless and air spray systems utilize the Nordson® Model NH-4 fluid heater to reduce the viscosity of coating materials and increase operating efficiency without adding solvents.